Is your client able to connect to the VPN server? The connection was prevented because of a policy configured on your RAS/VPNserver. > Remote Access Error: The following error occurred in the Point to Point Protocol module on port: VPN3-127, UserName XXX. >I can see in Remote Access Mgmt Console the user is connected, and one of the static IP's are assigned. It seems that your client failed to connect to the VPN server. This is a new server setup and the only thing on the Server besides I can VPN in, but am blocked with Windows Remote Desktop. Once each for IPv4 and IPv6 address.Īgain my goal: Very simple - Provide remote access to my server. The address of remote RADIUS Server xxxx in server group VPN-access resolves to Local address xxx, and will be ignored. All are set with PEAP and/or EAP-MSCHAPv2.I've triple checked NPS to make sure the policy was enabled and to grant access for VPN-Dial Up, DHCP and RGateway.Please contact the Administrator of the RAS server and notify them of this error. Method used by the server to verify your user name and password may not match the authentication method in your connection profile. Remote Access Error: The following error occurred in the Point to Point Protocol module on port: VPN3-127, UserName XXX. Also in Remote Access Mgmt Console under the domain name it shows: VPN [Services - Big red X with Operations status & state showing Critical& Services State respectively.I can see in Remote Access Mgmt Console the user is connected, and one of the static IP's are assigned.Group Policies, Remote Desktop all set and enabled.An address pool is setup with a pool of 3 static IP's.This router is configured with DHCP, IPv6 enabled, and allows me to assign the Static IP's to either of my two computer. Desired result (should be fairly simple-NOT): I need to access my server via Windows Remote Desktop via VPN from remote locations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |